Advertisement
ADJUSTMENTS
STEP 6
When you have finished all the above steps, if the hole at the bottom of hopper cannot be closed and opened
completely by using the handle you may need to the follow these additional steps.
•
The handle adjusts the spreader setting. When the handle is moved to "30", the adjustable plate is fully
open, when at "0", it is fully closed.
•
Loosen the wing nut on the Bracket and move the adjustment lever handle up or down depending on the
amount of material required. Pushing the handle down will release more material and pulling the handle
up will stop the flow entirely.
•
Tighten the wing nut when the desired position is reached.
To operate this spreader, push the handle to the lowest position (downwards). You may move the position
of the Wing nut on the Gauge & Lever to adjust the space on the hole between the hopper and the
adjustable plate as per your need when spreading.
Advertisement
