Leica mojoRTK How-To Manual page 2

Configuration
When the mojoRTK console starts up for the first time it will start a
configuration sequence designed to guide you through the initial setup of
the console.
The mojoRTK user manual explains the standard configuration settings for
the mojoRTK console (refer to the section 'Running the mojoRTK Console for
the First Time').
This part of the guide refers to the selection of the Leica Geosystems
QuickSteer kit and its setup for use with the mojoRTK console.
Once you have reached the vehicle type section of
1.
the setup sequence you need to select
'QuickSteer' as the vehicle type. Press OK to
confirm the selection.
A status screen will be displayed which indicates
2.
the status of the CAN bus and the QuickSteer. If
the message indicates that there is a problem,
check the cables and connectors and ensure that
the QuickSteer is powered up.
If it is the first time you have set up the
3.
QuickSteer or you are changing from another
steer kit then you will be prompted to perform a
steering adjustment procedure. Press OK to
continue.
Proceed through the remaining setup wizard stages following the
4.
prompts on screen and the instructions in the user manual.
For more information
www.mojoRTK.com
Page 2/5 Document #1034 rev1.3