Table of Contents
Advertisement
4.
Configuration should follow the method of connections as shown below.
•
When you use the power cord of three cores, you need to connect the power
cord with terminal plates. (Fig.1)
•
When you use the power cord of five cores, you only need to connect the
power cord. Do not throw away the terminal plates and remain them inside
terminal box in order to later need. (Fig.2)
•
L Brown
PE Green-Yellow
N Blue
5.
Tilt the top cover down and tighten the screws.
Before configure the ECO mode, Read the Installation Manual especially the "Safety
Warnings" section.
The induction hob must be connected to the mains supply only by a suitably qualified
electrician.
For power consumed exceed 13Amp, cable must be replaced to qualified 32A one.
Note: Do not throw away silicone sheet after changing the cable. Save it together with 13Amp
cable for subsequent replacement.
L1 Brown
L2 Black
PE Green-
Yellow
N2 Grey
Advertisement
Table of Contents
