Grundfos SEG AutoAdapt Installation And Operating Instructions Manual page 13

Type key
Example: SEG.40.11.E.Ex.2.1.5.02
Code Description
Grundfos sewage
SE
pumps
Grinder system in the
G
pump inlet
Nominal diameter of
40
outlet port
Nominal diameter of the
50 outlet port for high-flow
variants
P2 = code number from
11
type designation / 10
Standard, without
[ ]
equipment
Electronic version with
E
AUTO functions
ADAPT
[ ] Standard pumps
Ex Explosion-proof pumps
2 2-pole
1 Single-phase motor
[ ] Three-phase motor
5 50 Hz
02 230 V, DOL
0B 400-415 V, DOL
0C 230-240 V, DOL
[ ] 1st generation
A 2nd generation
B 3nd generation
Standard material
[ ]
(EN-GJL-200)
Z Custom-built pump
1)
The pumps in the individual generations differ in
design but are similar in terms of power rating.
Safety instruction and requirements
Designation
Type range
Impeller type
Pump outlet
[mm]
Output power
[kW]
Equipment
Pump version
Number of
poles
Number of
phases
Frequency [Hz]
Voltage and
starting method
1)
Generation
Pump material
Customisation
DANGER
Electric shock
Death or serious
personal injury
- Before starting work on
the pump, make sure
that the fuses have
been removed or the
main switch has been
switched off.
- Make sure that the
power supply cannot
be accidentally
switched on.
CAUTION
Crushing of hands
Minor or moderate
personal injury
- Do not put your hands
or any tool into the
pump inlet or outlet
port after the pump has
been connected to the
power supply, unless
the pump has been
switched off by
removing the fuses or
switching off the main
switch.
- Make sure that all the
rotating parts have
stopped moving.
13