Advertisement
Installation
Installation and removal of the polishing discs
Before installing or changing the polishing disc, make sure that the polishing machine is switched off
and unplugged.
1. Remove the flange nut from the shaft with a 24-sized wrench (size may vary depending on the
version). Note that the left washer nut is left hand threaded.
2. Remove the polishing pad.
3. Check the new polishing pad for damage.
4. Install the polishing pad and tighten the nut. Make sure the nut is properly tightened. If the nut
is too tight or too loose, it can cause problems during operation.
5. When restarting the machine, do NOT stand in front of the machine, but to the side. Allow the
polishing pad to turn without load for at least 30 seconds. If the machine vibrates heavily or if
any other damage is noticed, pull out the power plug immediately. Fix the damage before put-
ting the machine back into operation.
Caution: The polishing disc continues to rotate even after the plug has been pulled out.
•
Switching the machine on and off is safe when used properly. Follow all safety instructions,
but remember to use common sense in every situation and in all working conditions.
•
Never reach too far behind or under the rotating disc. Always stand aside when starting the
machine and let the machine run for at least 30 s without load to check that it is working
properly. Turn off the machine after use.
Maintenance
Regular maintenance extends the life of your polisher and reduces the risk of failure. Make sure that
the ventilation slots are always free so that the motor is adequately ventilated and cooled.
1. Unplug the power cord after use and remove any dirt from the ventilation slots, e.g. B. with a
vacuum cleaner.
2. Regularly check the power cord for damage. We recommend this test before and after each
use of the polishing machine.
3. Before each use, check that all moving parts are properly attached. Polishing pads that are too
tight or too loose can cause injury and malfunction.
4. Replace the polishing pads if necessary.
5. Clean the machine regularly.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item no. 62542
Page 6
09 2021-1
Advertisement
