Advertisement
Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation
instructions carefully and make sure you have understood its content.
Keep these operation instructions safe.
General safety information
Warning:
Use of the device is only permitted with a residual current circuit breaker with a triggering rated current
of up to 30 mA (according to VDE 0100 parts 702 and 738).
This device is not intended to be used by persons (including children) with limited physical, sensory or
mental capabilities or inadequate experience and / or inadequate knowledge, unless they are super-
vised or have been instructed by a person responsible for their safety on how to use the device. Chil-
dren should be supervised to ensure that they do not play with the device.
We recommend putting on suitable safety wear. It includes gloves, eye protection and a face
mask.
Keep the instructions in a safe and dry place so that you can refer to them at any time.
Safety in the work area
•
Keep your work area clean and well lit. Untidy and poorly lit work areas increase the risk of
accidents.
•
Never use electrical devices in an explosive environment, e.g. B. near flammable liq-
uids, gases or dust. Electrical appliances can cause sparks that can ignite these materials.
•
Keep bystanders and children away while you are using the electrical device. Distrac-
tions can cause you to lose control of the device.
Electric safety
•
Before connecting the device, make sure that the voltage of the power source corre-
sponds to the voltage specified on the rating plate.
•
Avoid body contact with earthed surfaces, e.g. B. pipes, heaters, stoves or refrigera-
tors. The risk of electric shock increases when the body is earthed. If you work in a damp en-
vironment, it is essential to use a residual current circuit breaker to supply your electrical de-
vice with electricity. Wearing rubber gloves for electricians and shoes with rubber soles also
increases safety.
•
Never expose electrical devices to rain or moisture. Water entering an electrical device in-
creases the risk of electric shock.
•
Handle the power cord carefully. Never carry devices by the power cord; Never pull the
power plug out of the socket by the cable. Keep the power cord away from heat, oil, sharp ob-
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item no. 62542
Page 3
09 2021-1
Advertisement
