Advertisement
jects, or moving parts. Replace damaged power cords immediately. Damaged power cords in-
crease the risk of electric shock.
•
If you want to operate an electrical device outdoors, always use an extension cable ap-
proved for outdoor use. Outdoor extension cords reduce the risk of electric shock.
•
Always set the switch to "Off" before connecting the device to the mains.
Personal safety
•
Remain vigilant and pay full attention to what you are doing while operating an electri-
cal appliance. Do not use the device when you are tired or under the influence of alco-
hol, intoxicants or drugs. A moment of inattention while using the device could result in seri-
ous injury.
•
Wear appropriate clothing. Do not wear loose clothing or jewelry. Tie long hair securely
together. Keep hair, clothing and gloves away from moving parts. Loose clothing, jewel-
ry, or long hair can get caught in moving parts. Keep the handles dry, clean, and free from oil
and lubricants.
•
Avoid unintentional starting. When plugging in, make sure the device's switch is in the
off position. When carrying an electrical device, do not put your finger on the trigger; a device
with the switch on must not be connected to the mains.
•
Remove the wrench before switching on the device. An adjusting wrench or wrench hang-
ing on a moving part can cause injury.
•
Don't lean too far. Always keep your balance and make sure you have a secure and firm
footing. A secure footing and maintaining balance allow better control of the device in unex-
pected situations.
•
Put on safety wear. Always wear protective goggles. Dust masks, non-slip shoes, hard hat
and hearing protection must also be worn under appropriate conditions.
Safety in use and care
•
Use clamps or other aids to secure workpieces to a stable surface. Workpieces should
always be fixed and not held in the hand, as this can lead to loss of control.
•
Do not apply pressure to the device. Always use the right device or tool for the job at
hand. Tools and equipment are safer and more reliable when used within their intended per-
formance range.
•
Do not use a device that has a defect switch. Any device that cannot be controlled by the
switch is dangerous and must be repaired immediately.
•
Pull the power plug before making changes, replacing accessories or storing the de-
vice. These safety precautions reduce the risk of unintentional switching on.
•
Store unused tools and devices out of the reach of children and inexperienced people.
Devices and tools in the hands of untrained people can be dangerous.
•
Always maintain equipment and tools with great care. Always keep cutting tools sharp
and clean. Properly maintained tools with sharp edges are less prone to deformation and eas-
ier to control. Any change or modification is to be regarded as misuse; this can lead to a haz-
ard.
•
Check the moving parts for deformation, misalignment, damage, or other conditions
that could limit the performance of the product. If the device is damaged, have it re-
paired by a specialist. Many accidents are caused by poorly maintained equipment or tools.
Establish a maintenance schedule for your device.
•
Only use accessories recommended by the manufacturer that are compatible with your
device. Accessories that fit a particular device can be dangerous when used on another de-
vice.
Intended use
The polishing machine is designed for polishing workpieces and other objects. The device is not in-
tended for commercial use. No structural changes/ modifications are allowed. Structural changes or
improper use can lead to property damage and personal injury.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item no. 62542
Page 4
09 2021-1
Advertisement
