ELGA CENTRA S200 US Operator's Manual page 32

CENTRA - S200 US/CENTRA - R200 US Operator Manual
Remote control station
selection screen
Programming of
user PASSkeys screen
Page 26
Step 20 - Remote control station selection (node
addressing)
Step 21 - Programming of user PASSkeys
CAUTION!
CENTRA - S200 US/CENTRA - R200 US Version 01 – 08/14
You can add up to seven remote control stations
connected to the CENTRA; they must each be registered
for its commands to be recognised.
Once registered the remote control station can be used
to adjust functionality and monitor alarms locally.
The viewing angle of each remote control station is
specific to its mounting position and should be adjusted
as described in Section 5.4, Step 16.
PRESS TICK  to complete settings (User
1.
PASSkey)
PRESS TICK  to proceed to step 21 (Master
PASSkey only).
Note: At this stage the CENTRA screen may timeout
before each remote display is registered. This
does not affect registration of the remote display.
2. ENSURE the RS485 network is correctly installed
and terminated as described in 'ELGA LabWater
Installation Guide - RS485 Local area Network
design considerations
(Available from ELGA LabWater Technical Support).
3. POWER ON remote control stations.
4. PRESENT user PASSkey (any colour) at each
remote display in the order that you wish them to be
registered.
Note: Re-enter the user menu and return to step 20 to
check the registration of the remote displays.
During the operational life of the CENTRA it may be
necessary to delete or add User PASSkeys to prevent or
allow access to user preferences. This feature is only
available to the Master PASSkey holder.
Do not press reset unless all user
PASSkeys
reprogramming.
1. PRESS RESET
PRESENT the new User PASSkey to the reader
(proceed to instruction 3).
2. PRESENT the new User PASSkey to the reader.
3. PRESS SETPOINT
identification.
4. REPEAT instruction 2 and 3 until all User PASSkeys
are registered (maximum of 8 users).
PRESS TICK  to complete settings.
5.
OR
and installation
are present
to delete all User Passkeys
OR
to load new User PASSkey
ELGA
guide'
for