ELGA
Viewing angle adjustment screen
Auto-restart screen
Data output screen
Data transmit screen
Step 16 - Display viewing angle adjustment
Step 17 - Auto-restart
Step 18 - Data output (printer or PC)
Step 19 - Data transmit
CENTRA - S200 US/CENTRA - R200 US Version 01 – 08/14
CENTRA - S200 US/CENTRA - R200 US Operator Manual
Note:
A highlighted box indicates that the unit will be
operational on that day between the times set in
step 14.
3.
REPEAT, step 15 - item 2, to select further operating
days or PRESS SHIFT until the TICK appears.
PRESS TICK .
4.
Note:
During selected off periods the unit can be
reactivated by pressing PROCESS. A few
minutes operation should be allowed before use.
The angle of the display can be electronically adjusted up
and down to optimize the display graphics visibility.
PRESS and HOLD UP or DOWN to adjust
1.
viewing angle
PRESS TICK to proceed to step 17.
PRESS TICK .
2.
This allows the selection of the AUTO/MANUAL restart
option. If
auto restart
automatically restart after a power failure.
mode the unit will remain in standby.
1.
PRESS SCROLL
PRESS TICK to proceed to step 18.
PRESS TICK .
2.
CENTRA can transmit operational data to a printer or PC
via a RS232 lap-link communication cable from the main
control display or any remote display, when the print icon
is pressed during operation.
1.
PRESS SCROLL
PRESS TICK to proceed to step 19.
PRESS TICK .
2.
The frequency at which data is automatically transmitted to
the printer or PC is selectable.
1.
PRESS SCROLL
(1, 5, 15, 30min / 1, 6 hour)
PRESS TICK to proceed to step 20.
PRESS TICK .
2.
Note:
PRESS PRINT during normal operation and data
will be transmitted to the recording device.
OR
is
selected the unit
In manual
to change mode ( = ON)
OR
to change mode ( = ON)
OR
to change transmit intervals
OR
will
Page 25