ELGA CENTRA S200 US Operator's Manual page 23

ELGA
Removal of securing screws
CENTRA electrical connection
Step 2 - Electrical supply connection
WARNING!
WARNING!
CENTRA - S200 US/CENTRA - R200 US Version 01 – 08/14
CENTRA - S200 US/CENTRA - R200 US Operator Manual
FAILURE TO CORRECTLY INSTALL
THE ELECTRICAL SUPPLY COULD
RESULT IN DEATH.
IF IN DOUBT CONTACT A QUALIFIED
ELECTRICAN.
1. ENSURE a suitable cable is available to connect the
CENTRA to the electrical supply.
Note: It is recommended that the unit is connected to a
local isolator with a single-phase industrial 20-
amp plug/socket arrangement.
FAILURE TO USE THE CORRECTLY
RATED CABLE COULD RESULT IN
FIRE AND DEATH.
IF IN DOUBT CONTACT A QUALIFIED
ELECTRICAN.
REGULATIONS,
ELECTRICIAN MAY BE REQUIRED TO
MAKE THIS CONNECTION.
2. REMOVE the two screws that secure the right-hand
edge of the door.
3. OPEN the door fully.
4. DIRECT the cable through the rear of the unit to the
power socket.
Note: The power cable should be routed avoiding
signal cables and sensitive circuitry.
5. LOCATE the electrical cover on the top of the unit
and REMOVE the eight securing screws and store in
a safe place.
6. CAREFULLY remove the cover and locate the
earthing point on the electrical back plate.
7. REMOVE the nut and washers securing the earthing
cable and store in a safe place.
Note: The electrical cover can now be completely
removed and stored safely.
8. LOCATE the cable restraint on the right of the
electrical back plate.
9. DIRECT the cable into the electrical section via the
cable tunnels.
10. UNSCREW the cable clamp and INSERT the supply
cable ensuring sufficient cable to reach the MCB
and earth point.
11. RETIGHTEN the screws.
12. PULL the cable firmly and ENSURE that the cable is
properly retained.
13. CONNECT the supply cable to the MCB ensuring
correct termination and polarization.
CHECK LOCAL
A LICENCED
Page 17