ELGA CENTRA S200 US Operator's Manual page 30

CENTRA - S200 US/CENTRA - R200 US Operator Manual
Continuous operation screen
Night service setting screen
Day selection screens
Page 24
Step 13 - Continuous operation
CAUTION!
Step 14 - Periods of operation
Step 15 - Operational day selection
CENTRA - S200 US/CENTRA - R200 US Version 01 – 08/14
alarm will be reset once power is removed for 5
seconds and then reinstated.
Continuous operation may be required in particular
circumstances or when demand for water fluctuates.
During long periods of recirculation
and low usage the water temperature
will rise. It is therefore recommended
that this function be only enabled
when water usage is on average >50
liters/hr and water is used every day.
1. PRESS SCROLL
PRESS TICK  to proceed to step 14.
Note: Proceed to step 16 if continuous operation is
selected ( = ON).
To maximize efficiency and reduce the likelihood of heat
build up the normal operational hours for the installation
can be selected.
During 'OFF' periods the unit will automatically enter
recirculation for a period of 10 minutes every two hours to
maintain water purity within the distribution loop.
1. PRESS SCROLL
PRESS TICK  to proceed to step 15.
PRESS UP  to increase or DOWN  decrease
2.
time in increments of 30 minutes.
3. PRESS SCROLL
time.
PRESS UP  to increase or DOWN  decrease
4.
time in increments of 30 minutes.
5. PRESS SCROLL
PRESS TICK .
6.
Note: Night service
Continuous Operation is not enabled.
Select days that the CENTRA is required to operate by
highlighting the appropriate box.
Monday = 1 through to Sunday = 7
1. PRESS SCROLL
PRESS TICK  to proceed to step 16.
2. PRESS SCROLL
( = Monday enabled)
PRESS SHIFT  to step to box (2).
to change mode ( = ON)
OR
to edit night service start time
OR
to step to night service end
to enter times.
will only be operational
to enter selection screen
OR
to highlight box 1
OR
ELGA
if