Table of Contents
Advertisement
4.7.3.2
Load Default
Reset the WIRELESS NVR settings to its out-of-box state. You can choose to reset all settings at once, or just settings on
specific menus. Restoring default settings will not delete recordings and snapshots saved to the hard drive.
Check the items you want to restore, or check Select All to choose all items. Click Apply to load default settings of your chosen
items.
4.7.3.3
Upgrade
1. Copy the firmware file (.sw file) to your USB drive, and insert the USB flash drive into the WIRELESS NVR's USB port.
2. Click Select File button to choose the firmware file in your USB flash drive, then Click OK.
3. Click Upgrade button to start system upgrade. The system upgrade will last around 5-10 minutes, please do NOT
power off the WIRELESS NVR or remove the USB from WIRELESS NVR during firmware upgrade.
DS1098-047
40
Advertisement
Table of Contents
