Table of Contents
Advertisement
2.2.3
Inserting Cable Head
Check the location of pin 1 before inserting.
Align pin 1 on the IC socket for an PLQP0120LA-A package on the user system with pin 1 on the
user system interface cable head, and insert the user system interface cable head into the IC socket on
the user system, as shown in figure 4.
2.2.4
Fastening Cable Head
1. Use a screwdriver whose head matches the screw head.
2. The tightening torque must be 0.054 N•m or less.
If the applied torque cannot be accurately measured,
stop tightening when the force required to turn the screw
becomes significantly greater than that needed when first
tightening. If a screw is tightened too much, the screw
head may break or an IC socket contact error may be
caused by a crack in the IC socket solder.
3. If the emulator does not operate correctly, cracks might
have occurred in the solder. Check conduction with
a tester and re-solder the IC socket if necessary.
CAUTION
CAUTION
Section 2 Connection Procedures
Rev. 3.00 Sep. 08, 2008 Page 7 of 18
REJ10J1396-0300
Advertisement
Table of Contents
