Table of Contents
Advertisement
Network echosounder mode
The network echosounder mode setting selects whether only one
or multiple echosounder sources can be selected at the same time.
Ú Note:
Single source is automatically selected if there are older
legacy echosounders on the network. You cannot change this
setting if older legacy echosounders are on the network. Multi-
source mode should be selected if no legacy echosounder is
connected to the network.
Ú Note:
When changing the mode to multi-source you must wait
30 seconds and then power down all sources. Wait 1 minute,
then restart all connected sources.
Use network depth and temp data
The unit can share depth and temperature data from an Ethernet
networked echosounder source over the NMEA 2000 network.
Use this option to select from which Ethernet network source the
data is shared.
Autopilot settings
The Autopilot settings dialog depends on which autopilot
computer that is connected to the system. If more than one
autopilot is connected, the Autopilot settings dialog shows option
for the active autopilot.
The settings are made during commissioning of the autopilot. Be
careful of changing settings after commissioning is completed.
NAC-1 specific installation settings
Commissioning
Used to calibrate your boat's steering (cable steer or hydraulic
steering) with the NAC-1.
System setup
| GO XSE/XSR Installation Manual
45
Advertisement
Table of Contents
