Simrad GO XSE Series Installation Manual page 54

54
Calibration
An offset (positive or negative) can be applied to correct data
inaccuracies from NMEA 2000 sources. The offset is set on the NMEA
2000 device.
Ú Note:
Select the advanced option to adjust local offsets for this
display only.
Ú Note:
It is typically not possible to calibrate 3rd party sensors.
However, a local offset can be applied.
NMEA 2000 setup
Receive waypoint
Allows waypoints to be received from devices that transmit a
waypoint over the NMEA 2000.
A waypoint will be received when the waypoint is created on the
other device, if the following settings are in place:
• The receiving device - the receive waypoint option must be set
to ON before the waypoint is created in the sending device.
• The sending device - the send waypoint option must be set to
ON before the waypoint is created.
Send waypoint
Allows this unit to send a waypoint to other devices over the NMEA
2000 network.
A waypoint will be transmitted when the waypoint is created, if the
following settings are in place:
• The sending device - the send waypoint option must be set to
ON before the waypoint is created.
• The receiving device - the receive waypoint option must be set
to ON before the waypoint is created in the sending device.
Ú Note:
The system can only transmit or receive one waypoint at
a time over the NMEA 2000 network. For bulk import or export
of waypoints see the operator manual.
System setup | GO XSE/XSR Installation Manual