Table of Contents
Advertisement
Adjust open array park angle
The park angle is the final resting position of the antenna relative to
the heading line of the radar when the radar is set to standby. The
antenna will stop rotating at the desired offset.
Adjust local interference reject
Interference from some onboard sources can interfere with the
Broadband radar. One symptom of this could be a large target on
the screen that remains in the same relative bearing even if the
vessel changes direction.
Halo light
Controls the levels of the Halo Radar blue accent lighting. The
accent lighting can only be adjusted when the radar is in standby
mode.
Ú Note:
The blue accent pedestal lighting might not be approved
for use in your boating location. Check your local boating
regulations before turning the blue accent lights ON.
Tune
The automatic tuning will work well in most installations. The
manual tuning is used if it is required to adjust the result from an
automatic tuning.
Reset radar to factory defaults
Clears all user and installer settings applied to the selected radar
source, and restores factory settings.
Ú Note:
Use this option with caution. Take note of current
settings first, especially those set by the operator if radar has
already been in active service.
Adjust range offset
The radar sweep should commence at your vessel (a radar range of
zero). You may need to adjust the radar range offset to achieve this.
If this is set incorrectly, a large dark circle in the center of the sweep
might occur. You might notice straight objects such as straight sea
walls or piers having curves or an indentation. Objects close to your
vessel may appear pulled in or pushed out.
System setup
| GO XSE/XSR Installation Manual
39
Advertisement
Table of Contents
