Toshiba TEC B-850 Series Key Operation Specification page 30

• System mode for users (Operable menus of the system mode are limited.)
Power OFF
[RESTART]
<1> Self-test
[RESTART]
<3> Fine Adjustment Value Setting
[RESTART]
<4> Test Print
[RESTART]
<8> PCL Emulation Setting
While holding the [FEED] and [RESTART] keys down, turn the power on.
Maintenance counter/Various parameters printout,
Printer self-test operation and results printout,
Thermal head broken dots check
[FEED]
Feed fine adjustment,
Cut position (stop position of the strip issue) fine
adjustment,
Back feed fine adjustment, X-coordinate fine adjustment,
Print density fine adjustment (Thermal transfer/Direct
[FEED]
thermal print mode),
Ribbon motor drive voltage fine adjustment,
Transmissive sensor manual threshold fine adjustment,
Lower reflective sensor manual threshold fine adjustment
Parameter setting, 1-dot slant line printout,
3-dot slant line printout, Character printout,
Bar code printout, Non-printing
Automatic printout for the assembly process
[FEED]
(Transmissive sensor/Lower reflective sensor)
Emulation setting
Print speed setting
[FEED]
Sensor selection
Print type setting
Issue type setting
Media setting
- 27 -