Table of Contents
Advertisement
1. Turn on the emulator according to the procedures described in the SH7046 E6000H Emulator
User's Manual (HS7046EPH60HE).
2. Verify the user system interface cable connections by checking the pin states with the extended
monitor and checking the bus states with the FILL command (emulator command). If an error
is detected, recheck the soldered IC socket and the location of pin 1.
3. The emulator connected to this user system interface board supports three kinds of clock
sources as the MCU clock. For details, refer to the SH7046 E6000H Emulator User's Manual
(HS7046EPH60HE).
To use the emulator internal clock
Select the clock in the emulator by the CLOCK command (emulator command).
To use the external clock on the user system
Supply the external clock from the user system to the emulator by inputting the EXTAL
pin (pin 73) on the user system interface board or connecting the crystal oscillator to the
XTAL (pin 74) and EXTAL pins. For details, refer to section 4, Clock Pulse Generator, in
the SH7046 Series Hardware Manual.
Figure 8 shows the clock oscillator on the user system interface board.
1 M
HCU04
EXTAL XTAL
System clock
Section 4 Verifying Operation
HCU04 HCU04
270
Figure 8 Clock Oscillator
HCU04
HCU04
47
To E6000H
emulator
HCU04
13
Advertisement
Table of Contents
