Table of Contents
Advertisement
Section 3 Installing the MCU to the User System
1. Check the location of pin 1 before inserting.
2. Use a Philips-type screwdriver whose head matches the
screw head.
3. The tightening torque must be 0.294 N•m or less.
If the applied torque cannot be accurately measured,
stop tightening when the force required to turn the screw
becomes significantly greater than that needed when
first tightening. If a screw is tightened too much, the
screw head may break or an IC socket contact error may
be caused by a crack in the IC socket solder.
4. If the MCU does not operate correctly, cracks might have
occurred in the solder. Check conduction with a tester
and re-solder the IC socket if necessary.
Check the location of pin 1 before inserting the MCU into the IC socket on the user system, as
shown in figure 7. After inserting the MCU, fasten the socket cover with the provided four screws
(M2.0
8 mm). Take special care, such as manually securing the IC socket soldered area, to
x
prevent the IC socket from being damaged by overtightening the screws or twisting the
components.
CAUTION
11
Advertisement
Table of Contents
