Lanner NCA-2510 Installation Manual

The rackmount rail kit can be purchased as an accessory for existing system
including models: NCA-2510, NCA-2512, NCA-2520, NCA-4010, NCA-4012,
NCA-4112, NCA-4025.
The rackmount kit contains the following items:
2x Fixed Brackets
2x Adjustable Brackets
4x Flat-head Screws
Ensure that you have the following parts and tools available:
2x Mounting Ears (Provided with system)
6x Mounting Ear screws
8x Rack-mounting screws
1x Screwdriver, number 2
You can mount the network appliance on four posts in a 19-in rack or cabinet by
using the rackmount kit.
Note: Installing the system in a rack requires two people: one person lifts the system
while the other secures it to the rack.
If you are installing multiple systems in one rack, install the lowest one first and
proceed upward in the rack.
© Lanner Electronics Inc. All Rights Reserved. All product specifications are subject to change without notice.
1. Attach the mounting ears to the front of the system chassis, using three (3)
mounting ear screws on each side to secure. Then, attach the fixed brackets to
the sides of the system, using two (2) flat-headed screws on each side to secure.
2. Slide the system into the rack, and secure the mounting ears to the rack, using
two (2) rack-mounting screws on each side.
Note: Ensure the rear of the system is supported throughout the process of
mounting the system into the rack.
P/N: 086W000457000