Rotor Selection - Thermo Scientific Sorvall WX100 Plus Instruction Manual

Rotor Selection

This centrifuge stores the maximum and average radius of each rotor in its internal memory� It provides a function that will
automatically calculate and display the relative centrifugal force (RCF) from a set speed and calculate and display the speed from an
RCF setting (for information, refer to section
Correctly selecting the rotor allows you to manage total run time and number of runs�
Rotor selecting procedure
Step Touchscreen operation
1 Press the Rotor indicator field in the Run
screen�
NOTE:
A rotor is selected when the name of a rotor
type is displayed in the Rotor indicator field� If
you wish to use another type of rotor, follow
the procedure below to select a different rotor�
2 Check that the desired rotor is displayed� If it
is, select it and press the [OK] button�
RCF (Relative Centrifugal Force) Display and Setting
Screen displays and notes
ƒ Rotor Management screen
When the selected rotor field turns blue, press the [OK]
ƒ
button to return to the Run screen�
The selected rotor type appears in the Rotor indicator field�
ƒ
You can select your rotor in the Rotor Management screen if
ƒ
you registered your rotor in advance� For information on how
to register a rotor, refer to section
If the name of the rotor type appears in the Rotor indicator
ƒ
field, you can use the [Cancel] button to clear it�
CAUTION: If you have selected a rotor on the Rotor Management
screen, make sure to check that the selected rotor (on the Rotor
Management screen) and the rotor that is installed in the centrifuge
have an identical serial number (the rotor serial number is also
displayed in the Rotor indicator field on the Run screen)� If the serial
number of the selected rotor differs from the serial number of the
rotor installed in the centrifuge, you cannot control total run time
and the total number of runs of both rotors�
32
Function)�
(Cancel) button
Rotor management�