HUANUO HNPS02 Instruction Manual

2 tiers printer rack

2 Tiers Printer Rack Instruction Manual

V2.0

Model: HNPS02

Thank you for choosing this HUANUO product! At HUANUO we strive to

provide you with the best quality products and services in the industry.

Should you have any issues, please don't hesitate to contact us at

Technical Support:

1-800-556-0533 Mon-Fri 8am - 8pm (CST)

Other Info:

support@huanuoav.com (US/CA)

Table of Contents

Need help?

Do you have a question about the HNPS02 and is the answer not in the manual?

Page 1 2 Tiers Printer Rack Instruction Manual V2.0 Model: HNPS02 Thank you for choosing this HUANUO product! At HUANUO we strive to provide you with the best quality products and services in the industry. Should you have any issues, please don't hesitate to contact us at...
Page 2 Supplied Parts Wire Shelf Wooden Board Pole Plastic Clip Nylon Caster Wrench x1 Step 1 Screw nylon casters [E] into the bottom of four poles [C] by wrench. Snap one pair of plastic clips [D] on the same groove of each pole as shown in the below image.
Page 3 Step 2 Keep the collar of the wire shelf [A] downward. Then slide the wire shelf [A] into the plastic clips from the top of each poles. Keep the collar downward Step 3 Insert the wooden board [B] into the top of the four poles to make it snug on the poles.
Page 4 NOTE: Put a towel between rubber mallet and wire shelf to prevent damage. Mallet Towel...