Advertisement
Table of Contents
3 TIERS PRINTER RACK
INSTRUCTION MANUAL
Website:
www.huanuoav.com
Model:HNPS01
Thank you for choosing this HUANUO product! At HUANUO
we strive to provide you with the best quality products and
services in the industry. Please share your experience of our
product with others at www.huanuoav.com/reviews if you
are satisfied. Should you have any issues, please don't
hesitate to contact us.
Technical Support:
1-800-556-0533 Mon-Fri 10am - 5pm (PST) (USA) (CAN)
Other Info:
support@huanuoav.com (US/CA)
2
Advertisement
Table of Contents
Related Manuals for HUANUO HNPS01
Summary of Contents for HUANUO HNPS01
- Page 1 3 TIERS PRINTER RACK INSTRUCTION MANUAL Model:HNPS01 Thank you for choosing this HUANUO product! At HUANUO we strive to provide you with the best quality products and services in the industry. Please share your experience of our product with others at www.huanuoav.com/reviews if you are satisfied.
- Page 2 Supplied Parts Wire Shelf Wooden Board Pole Plastic Clip Nylon Caster Wrench Step 1 Screw Nylon Casters [E] into the bottom of four Poles [C] by wrench. Snap one pair of Plastic Clips [D] on the same groove of each pole as shown in the below image.
- Page 3 Step 2 Keep the collar of the Wire Shelf [A] downward. Then slide the Wire Shelf [A] into the plastic clips from the top of each poles. Keep the collar downward Step 3 Set the shelf upright. Refer to Step 1, 2 to snap the plastic clips [D] on the same grooves of each poles at your desired position for the second wire shelf [A].
- Page 4 Step 4 Insert the plastic parts under the Wooden Board [B] into the top of the four poles to make it snug on the poles. Push firmly down the corners of the two wire shelves [A] by rubber mallet (not included) to make the wire shelf [A] secure onto the plastic clips.
Need help?
Do you have a question about the HNPS01 and is the answer not in the manual?
Questions and answers