GigRig G2 User Manual page 8

5. REMOTE SWITCHES – There are 4 remote switches in G2
accessed via two TRS (TIP, RING, and SLEEVE)
connections. The connections are as illustrated in the
diagram. These connections are LATCHING, not momentary
6. SERIAL NUMBER – Every G2 has its own unique serial
number. If you need to get in touch for any reason regarding your G2, please quote this
serial number
7. OUTPUTS 1 & 2 – These outputs are the point where the signal leaves G2 and heads
back to your amp. If you are using a single amp then use OUT1 ONLY! Out1 Is your
earth so it needs to be connected at all times to a good earth/ground. OUTPUT 2 is
isolated using a high quality audio transformer ensuring that you won't get earth loops.
Connect your second amp to OUTPUT 2 and choose the combination of outputs you
want using the OUTPUT selection buttons on the top panel.
8. VOLUME INSERT LOOP – The volume loop insert is the perfect place to put your
volume pedal. It is part of the POST AMP circuit and turned on when you have the
POST GAIN included on a preset. The VOLUME LOOP INSERT can also be used to
connect your amplifier's effects loop to G2. Check out the Special Functions section for
more info.
9. BANK UP – Connect any MOMENTARY switch here to access the upper bank of
presets.
P a g e 7
© TheGigRig Ltd 2013