GigRig G2 User Manual page 18

This is a great position to have the Post Gain amplifier if you use stereo effects as the amplifier will drive
the input to the stereo effects so any gain change will happen on both stereo outputs. To change the
position of the Post Gain circuit simply Power Up holding down footswitch 5. The effects loop buttons
will now flash. Press and hold the effects loop button you want your Post Gain/Volume Insert to be
AFTER. The lights will cycle and you're done. If I press Effects Loop button 4, then the post gain circuit
will be between loops 4&5.
Remember, that to use the insert loop, the Post Gain must be turned ON
P a g e 17
© TheGigRig Ltd 2013