GigRig G2 User Manual page 23

11. G2 A
You can permanently change the way your G2 functions using the Advanced Functions menu
below. Advanced functions are simple on/off settings you can change when powering up your
G2. These settings will be memorized even when you remove power from your G2.
To toggle various functions you just hold down the foot switch for the function you want to
change whilst connecting power to your rig. Try it. Hold down foot switch 1 and apply power;
your G2 will continuously flash the foot switch lights until power is removed again. Nothing will
change; all settings and memories will stay the same.
Here is a list of special functions, further details of these special functions can be found in this
manual.
Power up Special functions:
Hold Down 1 at power on. Continuous light show.
All switches are deactivated until power is removed and re applied.
Hold down 2 at power on. Factory settings!
you can lose all your patch settings! It's not too late yet; however, if you hold down 2 at power
on then you press and hold foot switch 3 for three seconds, all your user settings are lost and
your G2 resets totally back to factory settings. If you enter this mode TheGigRig Logo will flash
continuously. Removing the power at this point will exit this mode and nothing will be lost. 
Hold down 3 at power on Stereo or Dual Mono function. Out lights 1&2 will flash. Choose 1 for
dual mono function or 2 for stereo function. Set in Dual Mono it insures that both loops 9 & 10
will go through the POST GAIN amplifier and then to both outputs. In STEREO function when
using loops 9&10 only OUTPUT 1 will receive the POST GAIN amplifier. Factory preset is
stereo.
Hold down 4 at power on Phase mode, (Global or Patch) this toggles the way the phase
switch works.
In global mode the phase switch reverses the phase of output 2 with respect to output 1 no
matter what patch you have selected or weather Engage is selected (Ideal if you have a two
amp system).
In the more complex Patch mode the relative phase of output 2 can be selected for each of the
28 patches this is ideal if you have loops with none true phase pedals. Hold down foot switch 4
again at power on to toggle back to Global Phase mode.
These setting are memorized by your G2; it will remember everything you have set.
You can even move to Global mode without losing your patch mode settings.
P a g e 22
© TheGigRig Ltd 2013
F
DVANCED UNCTIONS
WARNING you have now entered a mode where