Advertisement
INSTALLATION
Set the unit so that its DIN rail adapter is at the bottom. When the unit is installed to an Installation Base (model M6SBS),
refer to its instruction manual.
■ MOUNTING THE UNIT ON A DIN RAIL
A) Hang the upper hook at the rear side of unit on the DIN
rail.
B) Push in the lower in keeping pressing the unit to the DIN
rail.
A
TERMINAL CONNECTIONS
Connect the unit as in the diagram below or refer to the connection diagram on the side of the unit.
■ EXTERNAL DIMENSIONS unit: mm (inch)
5.9 (.23)
B
DIN Rail
SCREWDRIVER *
INSERTION ANGLE
: approx. 35°
WIRE INSERTION ANGLE
: approx.35°
5
1
*Use a minus screwdriver: tip width 3.8 mm max., tip thickness 0.5 to 0.6 mm
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
■ REMOVING THE UNIT
A) Pull down the DIN rail adaptor using a minus screwdriv-
er.
B) Pull out the lower part of the unit.
C) Remove the upper part from the DIN rail.
C
DIN Rail Adaptor
TEST PROBE
max. 2 (.08) dia.
6
7
8
2
3
4
SCREWDRIVER
INSERTION ANGLE
: approx. 40°
102 (4.02)
• When mounting, no extra space is needed between units.
M6SXF3
B
A
DIN RAIL HOOK
DIN RAIL
35mm wide
[0.5 (.02)]
EM-7990 Rev.3 P. 2 / 5
Advertisement
