Installation - M-system R6-NE1 Instruction Manual

INSTALLATION

Use the Base Model R6x-BSA or B6x-BSB.
Before mounting the Network Interface Module onto the Base, be sure to configure the module as explained below.
■ DATA ALLOCATION
The setting determines the data area size assigned to each
I/O module mounted on the base.
The data sent/received via Modbus is mapped according to
this setting.
In order to use the second channel of analog I/O modules,
choose the Mode 2. (The 2nd channel cannot be sent/re-
ceived in the Mode 1.)
See "COMPONENT IDENTIFICATION."
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
■ NETWORK SLOTS ON THE BASE
Mount the Network Module to the dedicated slot on the
base.
• R6x-BSA
The I/O and the power (model: R6x-PF1) modules can be
positioned freely on whichever among the slots 1 through 8.
Set a module address to each I/O module.
Network I/O & Power Supply
Module
1 2 3 ・・・ 8
• R6x-BSB
The power module (model: R6-PSM) should be located on
the extreme left, the I/O modules can be positioned freely
on whichever among the slots 1 through 8. Set a module
address to each I/O module.
Power Supply Network
Module Module
R6-NE1
Modules
I/O Modules
1 2 3 ・・・ 8
EM-7787 Rev.7 P. 2 / 9