Horizontal Room Adjustment; Vertical Room Adjustment - Lippert Tiffin Through Frame Low profile Slide-out Installation Manual

Horizontal Room Adjustment

To move the slide room side to side:
Only perform this procedure if room is not centered in the slide opening. The room should be centered on
initial install. Room should be 3/4 of the way into the slide opening.
1. Loosen all the nuts (Fig. 14A) on each room mounting bracket (Fig. 12A), six total nuts.
2. Position room horizontally by pushing on the outside slide box end wall to make sure the box is
centered in the slide room opening (Fig. 8A).
NOTE: Gap on each side should be equal.
3. Tighten all the nuts (Fig. 14A) on each room mounting bracket (Fig. 12A), six total nuts.

Vertical Room Adjustment

If one side of the room is lower or higher than the other, make adjustments to just the affected side. If the
entire room needs to be raised or lowered, all three room mounting bracket vertical adjustment nuts
(Fig. 14B) will need to be adjusted to the same level, starting with one side, the middle and then the other side.
To raise or lower the slide room:
1. Loosen the nuts (Fig. 14B) on the room mounting bracket, adjust the room accordingly up or down.
Once room height is positioned, tighten the nuts (Fig. 14B).
2. Repeat step 1 for the other room mounting brackets if the entire slide room needs to move up
or down, moving next to the middle room mounting bracket and then the opposite side room
mounting bracket.
Rev: 08.20.21
Fig. 14
A
B
Page 9
CCD-0003696