Table of Contents
Advertisement
Manual Override
Resources Required
• Cordless or electric drill
• 1/2" socket
• 5/32" or 5/64"hex wrench
The slide-out system can be run with auxiliary power devices like cordless or electric power drills. In the
event of electrical or system failure, this manual method of retracting the cylinders can be used. A standard
hand-held drill is all that is required. To manually retract the slide out cylinders, do as follows:
1.
Insert a 5/32" hex wrench into the adjustment end of the valve (Fig. 20A).
NOTE: If a 5/32" hex wrench will not fit in the end of the valve, use a 5/64" hex wrench.
2.
Turn the hex wrench on the valve clockwise (Fig. 20) to allow the cylinders to be retracted.
3.
Remove the hex wrench from the valve. Remove the plastic cap (Fig. 21A) from the end of the motor.
Rev: 08.20.21
Fig. 20
A
Clockwise for Manual Override
Fig. 21
Page 17
A
CCD-0003696
Advertisement
Table of Contents
Need help?
Do you have a question about the Tiffin Through Frame Low profile Slide-out and is the answer not in the manual?
Questions and answers