Slide-Out Prior To Operation; Operation; Extending Slide-Out Room; Retracting Slide-Out Room - Lippert Tiffin Through Frame Low profile Slide-out Installation Manual

Slide-out Prior to Operation

Prior to operating the Lippert Hydraulic Through Frame Slide-out System, follow these guidelines:
1. Coach should be parked on the most level surface available.
2. Leveling or stabilizing system should be actuated to ensure coach will not move during operation of
slide-out system.
3. Be sure battery is fully charged.
4. Be sure to keep all persons and pets clear of slide-out system during operation.
NOTE: Install transit bars (if so equipped) on the slide-out room during storage and transportation.
Always make sure that the slide-out room path is clear of people and objects before and during
operation of the slide-out room. Always keep away from the slide rails when the room is being
operated. The gear assembly may pinch or catch on loose clothing causing personal injury.

Operation

Extending Slide-out Room

1. Level the coach.
2. Verify the battery is fully charged and hooked up to the electrical system.
3. Remove transit bars (if so equipped).
4. Press and hold the IN/OUT switch (Fig. 19) in the OUT position (Fig. 19B) until room is fully extended
and stops moving.
5. Release switch, which will lock the room into position.
NOTE: Only hold OUT switch until room stops.

Retracting Slide-out Room

1. Verify the battery is fully charged and hooked up to the electrical system.
2. Press and hold the IN/OUT switch (Fig. 19) in the IN position (Fig. 19A) until the room is fully retracted
and stops moving.
3. Release the switch. This will lock the room into position.
NOTE: Only hold IN switch until room stops.
4. Install the transit bars (if so equipped).
Rev: 08.20.21
Fig. 19
A
B
Page 15
CCD-0003696