Table of Contents
Advertisement
4.
Disconnect or shield power cables on the motor.
5.
Using a ½" socket and auxiliary drive device, e.g., cordless or electric drill, insert ½" socket onto the
coupler (Fig. 22A).
6.
Run drive device in reverse (counterclockwise) to retract cylinders (Fig. 22).
7.
After the cylinders have been fully retracted, remove the 1/2" socket and drill from the motor's coupler.
8.
Reinsert the 5/32" hex wrench into the valves' manual override adjustment (Fig. 23A).
9.
Turn the valve's manual override completely counterclockwise (Fig. 23) until the adjustment no longer
turns, thus completely closing the valves.
10. Do not over-tighten override set screws, as this can damage the valves.
Run Counterclockwise to Manually
Retract Cylinders.
Rev: 08.20.21
Fig. 22
A
Counterclockwise for normal operation
Page 18
Fig. 23
A
CCD-0003696
Advertisement
Table of Contents
Need help?
Do you have a question about the Tiffin Through Frame Low profile Slide-out and is the answer not in the manual?
Questions and answers