Table of Contents
Advertisement
Reservoir
Breather / Fill Cap
System Wiring Requirements
OEM-supplied circuit protection to be rated as determined by the OEM. All OEM-supplied wiring is to
conform to RVIA Standards.
1.
Battery power with OEM-supplied breaker conforming to RVIA Standards.
2.
Battery ground as per RVIA Standards.
3.
Connect a ground wire from the 12V battery to the ground post on the hydraulic power unit motor.
NOTE: Ground wires are OEM supplied.
Rev: 08.20.21
Fig. 18
Hex Plug
Pressure
Hydraulic
Switch
Manifold
Page 13
Hex Plug
Motor
Motor
Solenoid
Flow Divider
CCD-0003696
Advertisement
Table of Contents
Need help?
Do you have a question about the Tiffin Through Frame Low profile Slide-out and is the answer not in the manual?
Questions and answers