Attach Room Mounted Brackets To The Slide Room - Lippert Tiffin Through Frame Low profile Slide-out Installation Manual

Attach Room Mounted Brackets to the Slide Room

1. Once the slide-out room is in place, use the middle of the pre-drilled holes in the room mounting bracket
(Fig. 9A) as a guide to drill 11/32" pilot holes up through the floor of the slide room. These pilot holes will
be used as the guides to install the bolts down through the floor into the room mounting brackets.
2. At the pilot holes (Fig, 10C), install a 5/16" x 1 1/2" bolt (Fig. 10A) with a 5/16" flat washer (Fig. 10B) down
through the slide room floor and into the room mounting bracket.
3. Repeat step 2 for the other four pilot holes in the slide room floor.
4. Attach a 5/16" flat washer (Fig. 11B) and 5/16" nut on (Fig. 11C) the backside of the 5/16" bolt (Fig. 11A).
5. Repeat step 4 for the other four bolts on the other room mounting brackets (Fig. 12A).
Fig. 11
A
B
C
Rev: 08.20.21
Fig. 9
A
A
A
Page 7
Fig. 10
A
B
A
C
B
C
Fig. 12
A A
CCD-0003696