Install The Room Mounted Brackets To The Hydraulic Slide-Out - Lippert Tiffin Through Frame Low profile Slide-out Installation Manual

Install the Room Mounted Brackets to the Hydraulic Slide-out

1. Align the room mounting bracket (Fig. 3B) four holes with the four holes in the inner arm of the
hydraulic slide-out (Fig. 3A).
2. Attach a 5/16" flat washer (Fig. 3D) on a 5/16" -18 x 1" bolt (Fig. 3C) and attach the room mounting
bracket to the inner arm of the hydraulic slide-out.
3. Repeat step 2 for the other holes (Fig. 4).
B
C
D
4. Make sure the two welded bolts (Fig. 5A) for the vertical adjustment on the backside of the room
mounting bracket have a 5/16" flat washer (Fig. 5B) and 5/16" nut (Fig. 5C) installed. Later in the
installation, the top portion of the bracket can be adjusted vertically for final slide room adjustment.
5. Repeat step 4 for the other room mounting brackets (Fig. 6A).
Fig. 5
A
A
Rev: 08.20.21
Fig. 3
A
B
C
A
A
Page 5
Fig. 4
Fig. 6
A
CCD-0003696