Cable Tray Installation (Optional Extra) - UpDown Desk PRO Series Set Up And Operation Manual

2.6 Cable Tray Installation (Optional extra)

The cable tray can go wherever is practicable, depending on the location of your power points, your
screen cables, your computer cables etc. It's entirely up to you, however most people locate it
underneath the desk, to the rear and in the middle.
(Above example uses a 2 legged desk flipped upside down. The corner desk will require you to install from underneath
the desk)
On one side of the cable tray, you will notice a thin, soft padding. This side always goes against the
desk. It's to protect the desk from being scratched and prevent squeaking.
If you peer through each of the large holes of the cable tray, you will notice a small hole on the
other side. Using a screwdriver and a self-tapping screw, screw all the way through the soft padding
and into the timber. Screw both screws in firmly until they sit tight against the cable tray.
IMPORTANT: Before securing any part of the power cable to the cable tray, ensure you leave
enough cable for the desk to be raised to the standing position! Failure to do so may cause damage
to the power cable or your power point!
28