Desktops Installation - UpDown Desk PRO Series Set Up And Operation Manual

2.4 Desktops Installation

The following example assumes a 180cm desktop for the main desktop. Custom sizes will differ
slightly, but the principles are the same.
We now pre-configure the main desktop side. Per the earlier instructions, ensure the pivot plates
are at right angles to the spreader bars. Extend the leg/spreader bar assembly creating
approximately 10cm gap in the spreader bars as shown. The markings are in 5cm increments. These
measurements will result in approximately 10cm of overhang on the main desktop side. There is
flexibility on this distance depending on your requirements. For example, you may have under desk
drawers or obstacles that you need to work around.
Place the desktop onto the frame so that there is in approximately 10cm of overhang and desktop
is evenly central with respect to the spreader bars underneath. Do not attach the desktop with any
screws at this point.
21