UpDown Desk PRO Series Set Up And Operation Manual page 30

If you feel your desk's downward anti-collision feature is being activated too soon or not soon
enough, you can adjust its sensitivity.
1. Press and hold the 'M4' button for approximately 10 seconds until you hear the 2
beep. Release your finger from the button. The letter 'A' will be displayed.
2. Press 'M4' once
3. Use the 'Up' and 'Down' buttons to scroll through 1-4. 1 being the most sensitive, 3 being
the least sensitive and 4 turns off the anti-collision.
4. Press 'M3' twice to exit
If you make any errors or need to start the above instructions again, simply press the 'M3' button
twice.
B - Units – cm or inch
1. Press and hold the 'M4' button for approximately 10 seconds until you hear the 2
beep. Release your finger from the button. The letter 'A' will be displayed.
2. Use the 'Up' and 'Down' buttons to toggle through the menu until you reach 'B'
3. Press 'M4' once
4. Use the 'Up' and 'Down' buttons to scroll through 1-2. 1 indicates cm units, 2 indicates inch
units.
5. Press 'M3' twice to exit
If you make any errors or need to start the above instructions again, simply press the 'M3' button
twice.
C - Height correction adjustment
If you're adding a thicker or thinner desktop than 2.5cm or adding castor wheels, the display height
shown is going to be inaccurate. It should be adjusted.
1. Using the 'Down' button, lower your desk to the lowest possible height.
2. Take a tape measure and measure the distance from the ground to the top of your desktop.
Take note of this measurement.
3. Press and hold the 'M4' button for approximately 10 seconds until you hear the 2
beep. Release your finger from the button. The letter 'A' will be displayed.
4. Use the 'Up' and 'Down' buttons to toggle through the menu until you reach 'C'
5. Press 'M4' once
6. Use the 'Up' and 'Down' buttons to scroll through the heights until you reach your desired
minimum height.
30
nd audible
nd audible
nd audible