Control Panel Operation - UpDown Desk PRO Series Set Up And Operation Manual

2.7 Control Panel Operation

The Pro Series desk can be raised manually by pressing the Up/Down buttons or alternatively by
pressing pre-set heights using the M1 – M4 buttons.
To set a height on any given 'M' button, use the Up/Down buttons to achieve your desired position.
To store this height, press and hold an M button for 5-6 seconds until you hear an audible beep.
The display screen will show your current height. It is pre-set from factory to show the lowest
height at 64cm, which is measured to the top of a standard 2.5cm thick desktop. This can be
adjusted in the event you install a thicker desktop or castor wheels to your frame.
The desk has a built in 'anti-collision' safety feature whereby any interference or severe resistance
experienced automatically stops the up/down movement of the desk and rebounds it a small
amount. The sensitivity for this can be adjusted.
The Control Panel display will switch off after 30 seconds of no use. To reactivate, press the Up or
Down button once.
Control Panel Function Settings
A. 'Down' anti-collision sensitivity
B. Units – cm or inches
C. Height correction adjustment (when adding thicker desktop or castor wheels)
D. Minimum height setting (should you be placing an obstruction under the desk such as
pedestal drawers)
E. Maximum height setting (should you be placing an obstruction above the desk such as a
windowsill or printer tray)
F. 'Up' anti-collision sensitivity
A - 'Down' anti-collision sensitivity
29