UpDown Desk PRO Series Set Up And Operation Manual page 31

7. Press 'M3' twice to exit
If you make any errors or need to start the above instructions again, simply press the 'M3' button
twice.
D - Minimum height setting
If you have placed an obstruction under the desk such as pedestal drawers, you should set a
minimum height. This will ensure that an interference does not occur, and damage is not inflicted
to either the obstruction or your desk.
1. Using a tape measure, measure the height of the obstruction from the ground.
2. Press and hold the 'M4' button for approximately 10 seconds until you hear the 2
beep. Release your finger from the button. The letter 'A' will be displayed.
3. Use the 'Up' and 'Down' buttons to toggle through the menu until you reach 'D'
4. Press 'M4' once
5. Use the 'Up' and 'Down' buttons to adjust the height shown on the display. Add 2cm to the
distance you just measured of the obstruction.
6. Press 'M3' twice to exit. Your desk will not go below this height.
If you make any errors or need to start the above instructions again, simply press the 'M3' button
twice.
E - Maximum height setting
If you have an obstruction above the desk or above your monitors such as a windowsill or printer
tray, you should set a maximum height. This will ensure that an interference does not occur, and
damage is not inflicted to either the obstruction or your desk.
1. Using a tape measure, measure the height of the obstruction from the ground.
2. Press and hold the 'M4' button for approximately 10 seconds until you hear the 2
beep. Release your finger from the button. The letter 'A' will be displayed.
3. Use the 'Up' and 'Down' buttons to toggle through the menu until you reach 'E'
4. Press 'M4' once
5. Use the 'Up' and 'Down' buttons to adjust the height shown on the display. Subtract 2cm
from the distance you just measured of the obstruction.
6. Press 'M3' twice to exit. Your desk will not go above this height.
31
nd audible
nd audible