UpDown Desk PRO Series Set Up And Operation Manual page 26

At this point assess the desk to ensure the frame is approximately square and centred. The centre
leg should site at approximately 45 degrees to both other legs as shown below. There is a level of
variability allowed and a few degrees off will not affect operation. If adjustment is required, there
should still be enough movement within the frame to adjust its position.
Tighten up all 16 grub screws on spreader bars.
Tighten the loose M8 x 10mm screws on both pivot plates (2 on each plate)
Install all frame to desktop self tapping screws (2 per spreader bar and 2 for the short wing of the
centre leg).
Using the supplied Cable management straps, secure any loose and dangling cables. You should
raise/lower the desk entirely before finalising cable management of the power cable. The power
cable will be moving up and down with the desk and may cause damage if it's secured in place and
not enough slack has been allowed.
26