Specifications; Safety Recommendations - Winegard Trav'ler Pro SK2DISH Installation Manual

Before Installing the Antenna
You have selected the Winegard
Trav'ler Pro antenna will deliver the ability to view multiple satellites at the same time with unmatched signal strength, maximum HD
capabilities, and easy-to-use functionality—just like you get at home. This manual provides important information on the installation of
your Trav'ler Pro antenna on an RV. Please take time to read the manual in its entirety before installing or operating your antenna.

Specifications

Depending on location and DISH
following satellites can be accessed with the SK2DISH
during automatic operation: 110°, 119°, 129°.
Assembled unit (stowed): 9.943" H x 25" W x 42" L
Mount base: 21" W x 24" L
Unit weight: 44 pounds
Shipping weight: 71 pounds
Lift arms
A.
Skew housing
Under
10"
B.
FIGURE 1.A. Dimensions of SK2DISH
B. Stowed
skew housing,
A,B. Location of
lift arms, and lip at the base of the turret
Trav'ler Pro automatic multi-satellite TV antenna, with a low travel height (under ten inches). The
®
®
receiver type, the
®
42"
Lip of turret

Safety Recommendations

Do not attempt to install this system in the rain or under any
wet conditions. Moisture may affect electronics and void
your warranty.
Do not paint this antenna. Painting the Trav'ler Pro antenna
will void your warranty.
Pay attention to the pinch point as the antenna raises.
The pinch point should be labeled on the antenna (see
figure 2). Make sure the pinch point is free of obstructions
during the raise or stow sequence.
If you do not have access to a scissor lift, the recommended
way to carry the turret assembly to the roof is by the skew
housing, lift arms, or the lip at the base of the turret.
Do NOT carry the turret assembly by the feed arm or
plastic bracket at the end of the feed arm/LNB assembly
(figures 1.A,B).
25"
Pinch point (labeled)
FIGURE 2. Pinch point
1