3/16” or more exists, as it may damage the roof. See diagram at top of page 3. When installing the TRAV’LER on a rubber roof, Winegard recommends using the SKA-004 Roller Plate. If not using this plate, make sure that the roller does not come in contact with any rib supports or bubbles in the roof when in operation.
Page 3
See diagram of transition plate. Cable Entry Plate Installation: Winegard recommends in- Decide the best location for the cables to enter the vehicle. stalling the Accessory Detect...
Cable installation: Note: Connect the control cable and power cable to the back of the TRAV’LER Interface box as shown below. A. Press [ENTER] the TRAV’LER will return to the “Installation Menu” For cable runs longer than 25’ an extension may be purchased. Do not exceed 50’ of cable. FIGURE 5 Power Control Cable...
Receiver Setup: To order receivers or programming please call the Winegard receiver hotline: 1-(866) 609-9374. If you are not able to see all of your channels or the receiver displays an error, it may be necessary to go through the receiver set up once the TRAV’LER has finished a successful search.
Page 6
Customer must provide proof of purchase to verify the product is under warranty. If the product is brought to an authorized Winegard dealer for service prior to expiration of year one (1) of the warranty period and a defect in material or workmanship is verified by Winegard Technical Services, Winegard Company will cover the Winegard dealer’s labor charges...
Need help?
Do you have a question about the TRAV’LER SK-3003 and is the answer not in the manual?
Questions and answers