Advertisement
Safety Recommendations
Do not attempt to install this
system in the rain or under any
wet conditions.
NOTE
Antenna reception may vary based on transmitting antenna tower
height, lobe pattern of the transmitter, height of the receiving
antenna, weather conditions and terrain on receiving path including trees,
buildings and hills.
Specifications
• Range of up to 35 miles (performance may vary based on terrain and obstructions)
• For outdoor use only
• For VHF & UHF channels
• Amplified
• Dimensions: 7.6" tall, 14.9" diameter of antenna head
• Power required: 12 VDC at 85mA
• Aftermarket models: RS-3000 (white), RS-3035 (black)
NOTE
Model RP-RS30 (white) replacement head and model RP-RS35 (black)
replacement head are available. Repair parts are available at many
RV dealers and/or service centers throughout the country. If you don't have a
dealer/service center near you, call Winegard Company at 1-800-288-8094. All
major credit cards accepted.
Antenna head
Mounting screw
Rectangular gasket
1
Do not paint this antenna.
Painting the antenna will void
your warranty.
Coax cable running
from antenna head
Pedestal
Circular gasket
RoadStar Antenna
Choosing a Location for the Antenna & Power Supply
Before mounting the antenna, determine a location for the wall plate/power
supply. A coax cable will have to run from the antenna to the power supply
and from the power supply to each television. A 12 V connection must also be
made to the back of the power supply. Refer to the diagram on page 9.
After finding a location for the power supply, choose a location for the antenna.
Choose a location on the roof of the RV that meets the following requirements:
1
Offers enough support for a secure installation
2
Maintains adequate clearance from the edge of the roof and any
obstruction(s)
• clearance distance of 24 in. needed from center of antenna to front of
the vehicle
• clearance distance of 18 in. needed from center of antenna to nearest
obstruction and to the edge of the roof
Then choose a mounting option below.
If you would like to drill a hole directly beneath the antenna for cable entry
through the roof, follow the steps on page 3 for Mounting Option 1.
If you would like to drill a hole for cable entry in any place except for directly
underneath the antenna, follow the steps on page 5 for Mounting Option 2.
Cable entry plate
RoadStar Antenna
2
Advertisement
