Table of Contents
Advertisement
2.3
Installing the Front and Rear Anchor Baffle Plates
3
Installing Cables
1. Two power sources are used as an example.
2. If there is only one power source, the bypass input cables do not need to be connected and
the interconnecting copper bars do not need to be removed.
UPS Cable Connection Reference
3.1
•
When preparing cables, keep away from the cabinets to prevent cable scraps from entering
the cabinet. Cable scraps may cause sparks during power-on and cause personal injury or
device damage.
•
After cables are installed, clean the cabinets promptly. Ensure that there is no foreign
matter inside and around the cabinets.
•
Prepare terminals onsite. The length of the copper wire should be the same as that of the
part of the terminal that covers the conductor.
The cabling route is for reference only. Connect cables based on site requirements.
4
Advertisement
Table of Contents
