Selecting An Operating Mode - AERMEC WLRC40 User Manual

SELECTING AN OPERATING MODE

If the unit is on, press the
one operating mode to the next, in the sequence
shown below. COOL, HEAT and FAN modes can also be
selected via the dedicated buttons (refer to the REMOTE
CONTROL paragraph).
AUTO mode
COOL mode
The various operating modes have different features
and ranges:
• AUTOMATIC mode (AUTO): in this mode, the
remote control does not display any set-point value
and the fan speed is set to AUTO.
• COOLING mode (COOL): in this mode the user
must set the operating set-point and a fan speed;
if the room temperature is higher than the set
value (which can be seen on the display), the air
conditioner will continue to cool the air until the
room temperature reaches the set-point value.
• DEHUMIDIFICATION mode (DRY): in this mode the
user must set the operating set-point but not the fan
speed (which remains fixed at minimum); if the room
temperature is higher than the set value (which
can be seen on the display), the air conditioner
will continue to dehumidify the air until the room
temperature reaches the set-point value.
• VENTILATION mode (FAN): in this mode the user
must only set the fan speed. This mode provides no
heating or cooling, using only the internal fan to
ventilate the room.
• HEATING mode (HEAT): in this mode the user must
set the operating set-point and a fan speed; if the
room temperature is lower than the set value (which
can be seen on the display), the air conditioner will
continue to heat the air until the room temperature
reaches the set-point value.
button to pass from
MODE
DRY mode
HEAT mode
FAN mode
ON/OFF
FAN
CLOCK
X-FAN
TURBO SLEEP
Selecting the operating mode
MODE
TIMER ON
TEMP
TIMER OFF
LIGHT
WIFI
ON
ON/OFF
Cool Heat
Fan I Feel
Mode
T-ON Clock T-OFF
X-Fan Temp
Light Sleep Wifi
7