Remote Control - AERMEC WLRC40 User Manual

SYNCHRONISING THE REMOTE CONTROL WITH
THE INDOOR UNIT:
When the unit is in standby, stand no more than
2m away then press and hold the
3 seconds. The remote control and the unit will
be automatically synchronised. If the operation
is successful, the unit will emit 3 beeps; if it fails,
there will be no beep and you must repeat the
operation.
Frequency band(s) that the radio equipment
works in: 2400 MHz-2483.5 MHz
Maximum radiofrequency power transmitted in
the frequency bands that the radio equipment
works in: 13 dBm

REMOTE CONTROL

• Some of the buttons of the remote control are not used
for this air conditioner, and are therefore not described in
these instructions. The pressing of these buttons will not
affect the operation of the air conditioner.
• Check there are no obstructions between the receiver and
the remote control.
• The maximum distance between the IR receiver and the
remote control for ensuring a good signal is 8 metres.
• Position the remote control at least 1 metre away from TVs,
radios, stereos, etc.;there may be some audio and video
interference.
• Do not drop or throw the remote control.
• Do not let liquids enter the remote control, and do not
leave it in direct sunlight or in hot places.
• When the remote control sends a signal, the symbol
appears on the display and the indoor unit receiver emits a
sound to confirm reception of the signal.
Index Function of the button:
1
Switches the unit on or off
Increases or decreases the value of the active function:
• Temperature
2
• Time
• ON timer
• OFF timer
3
Activates or deactivates cooling mode
4
Activates or deactivates heating mode
5
Sets the ventilation speed
6
Activates or deactivates the iFEEL function
Sets the operation of the motorised air delivery fin
7
(vertical swing)
8
Selects the operating mode
Sets the operation of the motorised air delivery fin
9
(horizontal swing)
10
Activates (T-ON) or deactivates (T-OFF) timer mode
4
Fan I Feel
Mode
T-ON Clock T-OFF
button for
X-Fan Temp
Light Sleep Wifi
WIFI
ON/OFF
MODE FAN
SWING I FEEL
SLEEP
HOUR ON OFF
1
2
3
Cool
5
Fan
7
10
T-ON
12
15
Light
11
Sets the time on the system clock
12
Activates the HEALTH or AIR function
13
Activates the prolonged ventilation function
The indoor unit display shows the temperature set-point
14
and the room or outside air temperature
Activates or deactivates the visualisation of information
15
on the indoor unit display
Activates or deactivates the SLEEP function (this function
is applicable to cooling and heating mode); once
16
activated, this function will control the unit in order to
maintain an ideal temperature (which is automatically
calculated and cannot be set)
17
Activates or deactivates the WIFI card
18
Liquid crystal display
19
IR transmitter
19
WIFI
INTELLIGENT
18
ON/OFF
Heat
I Feel
Mode
8
Clock T-OFF
11
X-Fan Temp
13
Sleep Wifi
4
6
9
14
17
16