Part Names And Functions - Panasonic ZEQUO 6700RE Installation Manual

2

Part Names and Functions

Fan module slot 1
Back panel
Ground terminal
Front panel
SD card slot
 Power module slots (POWER 1, POWER 2)
Power supply redundancy can be realized by using additional power modules.
Connect the supplied power cord, and connect it to the power outlet.
 Fan module slots (FAN 1, FAN 2)
The fan modules are replaceable. Normal operating requires 2 fan modules.
 Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull out
from the power port.
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
 SD card slot
Insert an SD card into this slot to change/save settings and firmware.
 SFP extension slot (ports 1 - 24)
SFP modules can be implemented (ports 21 - 24 will be exclusively used with
twisted-pair ports).
 10BASE-T/100BASE-TX/1000BASE-T port (ports 21 - 24)
Connect 10BASE-T/100BASE-TX/1000BASE-T terminals, hubs, repeaters, bridges,
and Ethernet Switches, etc.
Set the twisted-pair cable (CAT5e or above) lengths so that they will fall within
100 m or shorter.
 SFP+ extension slot (ports 25 - 28)
An SFP or SFP+ module can be connected.
 Stacking port (ports 29, 30)
Up to four units can be stacked by 40G direct attach cables.
 Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage this
Ethernet Switch.
Transmission mode
Transmission speed
Stop bit
Flow control
12
Fan module slot 2
MAC Address label
Serial number label
10BASE-T/100BASE-TX/1000BASE-T port
SFP extension slot
Console port
: RS-232C Emulation mode
: 9,600 bps
Data length
: 1 bit Parity control
: None Transmission connector : RJ45
Power module slot 1
Power cord hook block
Power module slot 2
SFP+ extension slot
: VT100
: 8 bits
: None
Stacking port