Part Names And Functions - Panasonic GA-MLi8TPoE+ Installation Manual

2

Part Names and Functions

10/100/1000BASE-TX ports supporting PoE power supply
GA-MLi8TPoE+
LED DISPLAY
Front panel
CHANGE BUTTON
KEEP PRESSING 3SEC
ECO MODE ON/OFF
Back panel
 Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
 Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull
out from the power port.
 Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
 10/100/1000BASE-T ports (ports 1-10)
Ports 1 to 8 can supply PoE power confirming with IEEE802.3at/af.
Devices such as 10/100/1000BASE-T terminal, hub, repeater, bridge, and Ethernet
Switch can be connected to this port. Install the device so that the length of twisted
pair cable (CAT5e or above) becomes 100m or less.
 SFP extension slot (ports 9,10)
Install SFP module. (It becomes exclusive usage with twisted pair port.)
When SFP extension slot is linked, the ports are automatically switched to SFP
extension mode.
SFP port supports only the full duplex communication.
 Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage
this Ethernet Switch.
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
Flow control
12
LEFT LED（ORANGE）：LOOP DETECTION
1 3
ECO MODE
ON･･･BLINK
OFF･･･LIGHT
POWER STATUS/ECO
PoE LIM. GIGA
TEMP FULL
LOOP
FAN
HISTORY
2 4
Power cord hook block
Ground terminal
Emulation mode
Data length
: 1 bit Parity control
: None Transmission connector : RJ45
10/100/1000BASE-TX ports
5 7 9
SFP▲
6 8 10 SFP▼
Console port
AC100-240V
Power port
SFP extension slot
CONSOLE
9600.N.8.1（DTE）
Serial Number label
: VT100
: 8 bits
: None