Part Names And Functions - Panasonic PN26161K-NZ Installation Manual

Table of Contents

Advertisement

2

Part Names and Functions

Back panel
ZEQUO 2310
Front panel
POWER
STATUS
SD CARD
SD card slot
 Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
 Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull out
from the power port.
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
 SD card slot
Insert an SD card into this slot to change/save settings and firmware.
 10/100/1000BASE-T port (ports 1–20)
Devices such as 10/100/1000BASE-T terminal, hub, repeater, bridge, and Ethernet
Switch can be connected to this port . Install the device so that the length of twisted
pair cable (CAT5e or above) becomes 100 m or less.
Communication mode on ports 17 to 20 support full-duplex mode only. Half-duplex
mode is not supported.
 SFP extension slot (ports 17-20)
Install SFP module. (It becomes exclusive usage with twisted pair port.)
When SFP extension slot is linked, the port is automatically switched to SFP extension
mode.
SFP port supports only the full duplex communication.
 Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage this
Ethernet Switch.
Transmission mode
Transmission speed
Stop bit
Flow control
Power port
Power cord hook block
AC 100-240V
MAC Address label
CONSOLE
9600.N.8.1(DTE)
SD CARD SLOT
Console port
: RS-232C
: 9,600 bps
: 1 bit
: None
Serial number label
10BASE-T/100BASE-TX/1000BASE-T port
1
3
5
7
9
2
4
6
8
10
Serial number label
Emulation mode
Data length
Parity control
Transmission connector : RJ45
MAC Address label
Ground terminal
11
13
15
17
19
SFP▲(17)
SFP▲(19)
12
14
16
18
20
SFP▼(18)
SFP▼(20)
SFP extension slot
: VT100
: 8 bits
: None
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pn26161k-thPn26161k-myPn26161k-idPn26161k-sgZequo 2310

Table of Contents